Stock Status Report As of Date

Yahoo Archive
1
That would be really good for us to know at this juncture as well.

Troy Funte
Liberty Electronics

----- Original Message -----
From: Mike Lowe
To: vantage@yahoogroups.com ; Socalvantage@yahoogroups.com
Sent: Wednesday, May 09, 2001 7:24 PM
Subject: [Vantage] Stock Status Report As of Date


I was wondering if anyone using Vantage version 5 knew whether the following
issue has been fixed.

On version 3 (and I'm told this reflex works the same on version 4) you have the
ability to print the Stock Status Report for a specific "As of Date". If you
run the report for a previous as of date AND check the box "exclude parts with
zero quantities" you may potentially have different results. This is due to the
fact that as the report runs, it first filters for zero onhand TODAY. If there
is no onhand today it moves to the next part bin record. It does not consider
that there may have been parts onhand at a previous date since it doesn't even
get to this part of the subroutine.

Any feedback from version 5 users would be greatly appreciated.

Mike Lowe
Corporate I.S. Manager
Connor Manufacturing Services
MLowe@...



To access the Files Section of our Yahoo!Group for Report Builder and Crystal Reports and other 'goodies', please go to: http://groups.yahoo.com/group/vantage/files/. Note: You must have already linked your email address to a yahoo id to enable access.

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.



[Non-text portions of this message have been removed]
2
I was wondering if anyone using Vantage version 5 knew whether the following
issue has been fixed.

On version 3 (and I'm told this reflex works the same on version 4) you have the
ability to print the Stock Status Report for a specific "As of Date". If you
run the report for a previous as of date AND check the box "exclude parts with
zero quantities" you may potentially have different results. This is due to the
fact that as the report runs, it first filters for zero onhand TODAY. If there
is no onhand today it moves to the next part bin record. It does not consider
that there may have been parts onhand at a previous date since it doesn't even
get to this part of the subroutine.

Any feedback from version 5 users would be greatly appreciated.

Mike Lowe
Corporate I.S. Manager
Connor Manufacturing Services
MLowe@...