Trying to print a job traveler and getting "Error code 997". Job was just
entered today and have been entering and printing jobs without any problems.
The jobs before and after this job# printed fine. Even flagged this job as a
template and created a new job but still got the error message. Anyone have
any ideas what may have caused this? Solution was to start from scratch and
re-enter all the information. Thankfully it was only a single assembly with
a few operations and very much detail. We are on Vantage 3.00.632 Progress
8.3A.
Thanks,
Jim
entered today and have been entering and printing jobs without any problems.
The jobs before and after this job# printed fine. Even flagged this job as a
template and created a new job but still got the error message. Anyone have
any ideas what may have caused this? Solution was to start from scratch and
re-enter all the information. Thankfully it was only a single assembly with
a few operations and very much detail. We are on Vantage 3.00.632 Progress
8.3A.
Thanks,
Jim