I am looking to setup auto-printing to a zebra label printer. When I print the label from Vantage without using autoprint, the label prints out fine. However, when I enable auto-printing the label prints out but the text on the right-hand side of the label (about an inch) is being cut off.  Has anyone seen something similar to this? Any ideas on how I can get this resolved?
Thanks,
 Dustin Biniek
UMC, Inc.
DustinB@...
[Non-text portions of this message have been removed]
Thanks,
 Dustin Biniek
UMC, Inc.
DustinB@...
[Non-text portions of this message have been removed]