Dump and Load?

Our last d&load took approx 5 hours on Vantage 4 db size ~700 Megs. Speed increase after was ~60% faster.
You do need the utility from epicor to do this on V4.

Regards,
David Sloan
IT Manager
Entech Integrated Technologies

Phone: +61 8 8245 6789
Fax: +61 8 8245 6788
Direct Phone: +61 8 8245 6732
Postal Address: PO Box 1141, Marleston SA 5033
Site Address: 37 Belford Ave, Devon Pk SA 5008
================================
email: dsloan@...
Web: http://www.entechgroup.net
================================
----- Original Message -----
From: Tim Care
To: vantage@yahoogroups.com
Sent: Friday, July 06, 2001 12:07 AM
Subject: [Vantage] Dump and Load?


Has anyone done a dump and load on their Vantage
Database? If you have, how long did it take, and
what was your database size?

It looks like this is the next step for doing our 5.0
conversion. Just looking for some information from
somebody who has gone through it.

Thanks

Tim Care
Electro Chemical Finishing


To access the Files Section of our Yahoo!Group for Report Builder and Crystal Reports and other 'goodies', please go to: http://groups.yahoo.com/group/vantage/files/. Note: You must have already linked your email address to a yahoo id to enable access.

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/




[Non-text portions of this message have been removed]
Has anyone done a dump and load on their Vantage
Database? If you have, how long did it take, and
what was your database size?

It looks like this is the next step for doing our 5.0
conversion. Just looking for some information from
somebody who has gone through it.

Thanks

Tim Care
Electro Chemical Finishing
Our d&l took 16hrs on a 1.5gb database

--- In vantage@y..., "Tim Care" <ecfmis@e...> wrote:
> Has anyone done a dump and load on their Vantage
> Database? If you have, how long did it take, and
> what was your database size?
>
> It looks like this is the next step for doing our 5.0
> conversion. Just looking for some information from
> somebody who has gone through it.
>
> Thanks
>
> Tim Care
> Electro Chemical Finishing