Blank Title 27250

Yahoo Archive
1
Have you tried to do a "Receipt from Manufacturing" in Inventory Management?
It allows you to specify a job and assembly to put it to.

Edward F. Fox, Jr., CPA
Controller
Maxson Automatic Machinery Company
Phone: 401-596-0162 x110
Fax: 401-596-1050
www.maxsonautomatic.com


-----Original Message-----
From: Fredy Venczel [mailto:fvenczel@...]
Sent: Friday, June 20, 2003 12:00 PM
To: 'vantage@yahoogroups.com'
Subject: [Vantage]


I have a non stock part (doesn't exist in Vantage part master) on an R & D
job and now I want to take it off that job and put it on another job. A part
has been created in the part master now. I'm not sure how to handle this.
I'm on version 5.0.


Fredy Venczel


Useful links for the Yahoo!Groups Vantage Board are: ( Note: You must have
already linked your email address to a yahoo id to enable access. )
(1) To access the Files Section of our Yahoo!Group for Report Builder and
Crystal Reports and other 'goodies', please goto:
http://groups.yahoo.com/group/vantage/files/.
(2) To search through old msg's goto:
http://groups.yahoo.com/group/vantage/messages
(3) To view links to Vendors that provide Vantage services goto:
http://groups.yahoo.com/group/vantage/links

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
2
I have a non stock part (doesn't exist in Vantage part master) on an R & D
job and now I want to take it off that job and put it on another job. A part
has been created in the part master now. I'm not sure how to handle this.
I'm on version 5.0.


Fredy Venczel